Configuring NTP on the vCenter Server Appliance 6.0 (2113610)[Copy From VMware]

By | 2017年6月1日

Purpose

This article provides the steps to enable and add NTP servers on the vCenter Server Appliance 6.0.

Resolution

To enable NTP on the vCenter Server Appliance 6.0:
  1. Open a console session to the vCenter Server Appliance and press ALT+F1.
  2. Log in using the root user credentials.
  3. Run this command to view the current settings:

    ntp.get

    For example:

    Config:
    Status: Down
    Servers:

  4. Run this command to add an NTP server:

    ntp.server.add –servers ntp_servername

  5. Run this command to enable the NTP server:

    timesync.set –mode NTP

  6. Run this command to verify the NTP server settings:

    ntp.get

Note: To remove an NTP server, run this command:

ntp.server.delete –-servers ntp_servername

Additional Information

For more information, see the Add or Replace NTP Servers in the vCenter Server Appliance Configuration section of the vCenter Server Appliance Configuration Guide.

发表评论

电子邮件地址不会被公开。 必填项已用*标注